![]() The way we do this is to first click on the Run ULP button on the toolbar above our circuit design. Once the DRC comes up clear we can move on to our next step. Be sure to run the DRC and check for errors and adjust as needed.Next you just use autorouter again to rewire your circuit with the bigger leads.In which case you just need to adjust your circuit or you can have all of the wiring taken off using the Ripup command, followed by the stoplight button.You may get a list of errors like this:.Next you click “Check” to see what parts of your board are too close together.For this project we adjusted them to 30mil. Then change the size of the traces as big as you think you need. You also may want wider traces you can accomplish this while we are in the DRC, click on the “Sizes" tab.Next we need to change all of the options to 15mil as this setting seems to work well with the tip we are using for our CNC machine so we set this as our clearing width.We do this by pressing the DRC button on the side panel. ![]() We are going to need to use EAGLE to enforce design limitations. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |